CONCRETE CONSTRUCTION JOINTS
Concrete structures are subjected to a variety of stresses. These stresses are the result of shrinkage and differential movement. Shrinkage occurs during hydration, and differential movement is caused by temperature changes and different loading conditions. These stresses can cause cracking, spalling, and scaling of concrete surfaces and, in extreme cases, can result in failure of the structure.
TYPES OF JOINTS
Stresses in concrete can be controlled by the proper placement of joints in the structure. Well discuss three basic types of joints: isolation joints, control joints, and construction joints.
Isolation joints are used to separate (isolate) adjacent structural members. An example is the joint that separates the floor slab from a column. An isolation joint allows for differential movement in the vertical plane due to loading conditions or uneven settlement. Isolation joints are sometimes called expansion or contraction joints. In this context, they allow for differential movement as a result of temperature changes (as in two adjacent slabs). All isolation joints (expansion or contraction) extend completely through the member and have no load transfer devices built into them. Examples of these are shown in figures 7-32, 7-33, and 7-34.
Figure 7-34.-Expansion/contraction joint for a bridge.
Movement in the plane of a concrete slab is caused by drying shrinkage and thermal contraction. Some shrinkage is expected and can be tolerated, depending on the design and exposure of the particular structural elements. In a slab, shrinkage occurs more rapidly at the exposed surfaces and causes upward curling at the edges. If the slab is restrained from curling, cracking will occur wherever the restraint imposes stress greater than the tensile strength. Control joints (figure 7-35) are cut into the concrete slab to create a plane of weakness, which forces cracking (if it happens) to occur at a designated place rather than randomly. These joints run in both directions at right angles to each other. Control joints in interior slabs are typically cut 1/3 to 1/4 of the slab thickness and then filled with joint filler. See table 7-1 for suggested control joint spacings. Temperature steel (welded wire fabric) can be used to restrict crack width. For sidewalks and driveways, tooled joints spaced at intervals equal to the width of the slab, but not more than 20 feet (6 meters) apart, should be used. The joint should be 3/4 to 1 inch deep. Surface irregularities along the plane of the crack are usually sufficient to transfer loads across the joint in slabs on grade.
Figure 7-35.-Control joints.
Table 7-1.-Suggested Spacing of Control Joints
Construction joints (figures 7-36,7-37,7-38, and 7-39) are made where the concrete placement operations end for the day or where one structural element is cast against previously placed concrete. These joints allow some load to be transferred from one structural element to another through the use of keys or (for some slabs and pavement) dowels. Note that the construction joint extends entirely through the concrete element.
|David L. Heiserman, Editor||
Copyright © SweetHaven
Revised: June 06, 2015